Bell Pivot Kit SRV-1 287 | SRV-8

Bell Pivot Kit SRV-1 287 | SRV-8Pivot kit SRV 1 to suit Visor 287 SRV 8 How to identify Visor Bell shields made after 2006 will have the shield type number stamped into one side of the shield. Looking at the helmet from the front. The number will be stamped on the left hand side, running down the edge of the Visor. Typical Bell Visor Numbers 276 281 287 SRV 8 SE03 SE05 SE06 SE07 SE77

Fully adjustable between 30 PSI and 120 PSI (2-8 BAR)

***Installation note: It is extremely important with solid carrier bearing that your drive line is lined up correctly and operates smoothly

1x Pair of Rear upper control arms

The CFC Unit is delivered with everything you need to install the fuel pumps of your selection

The second type does not need the extra flat section since the whole door side molding is more flush/flat with the car and has an equal radius along the top and bottom

Pair of 3mm slip ons

Predrilled shell to allow cooling kit installation (HC/913)

We recommend using our lateral locks (sold separately) to prevent the swaybar from sliding side to side in these smooth bushings

4 slotted plates and 4 cover plates in 6061AL with 2 130mm grade 10

Pair of our steel braided lines and fittings for Z32 caliper conversion including: Quantity 2 ~ 3AN Male to 10mm x 1

Easy and accessible mounting with a wide variety of options and fuel filter brackets

Integrated 2-liter surge tank