K&N Custom Racing Assembly (56-9335)

K&N Custom Racing Assembly (56-9335)K&N Custom Air Filters for Single or Two Barrel Carburetors K&N custom air filter kits are designed to boost performance from your carburetor while keeping the dirt on the outside where it belongs. These assemblies come with custom chrome top and base plates and the famous K&N High Flow Washable Air Filter. Designed to increase horsepower and acceleration Show quality with custom chrome top and base Washable and reusable air filter High air flow with

The PreCharger will stop small dirt particles with minimal restriction to the airflow of the filter

Fits 390-800 cfm 4-Barrel Holley carbs with unmodified choke tower

helping you fine-tune the sensitivity of your throttle response

This hood scoop plug is designed for a scoop with a 58 square inch opening

K&N couplers are constructed from high-quality reinforced rubber and they are made to last

so it can be washed with K&N synthetic air filter cleaner then reinstalled to use again and again

The base does not have any holes cut through

Polished stainless steel

Foam wrap pre-filter included

Flow tested assembly for optimal air flow and minimal pressure loss

9 inches long

See the product specifications for CARB status on each part for a specific vehicle