PSM E36 Motor Mount Reinforcement

PSM E36 Motor Mount ReinforcementListing is for: 1x Set of reinforcement plates ~Help prevent common tearing of engine mount brackets on the front subframe ~1 8" steel weld in plates for the upper and lower side of the e36 cross member motor mount, make sure that the single bolt wont bend or break out of the OEM sheetmetal especially with increased horsepower. Fits great due to the 3D scanned and laser cut design. Sold as a set of 4 pieces.

~ Gold hard anodized finish

To comply with FIA regulations

We are now we are making it available separately

Bolt on alternative to crossmember modification/rack relocation

~ Features rotatable front camber/caster plates with ability to be offset for use with extended control arms

~Adds 45mm additional tie rod length so the OEM tie rods will reach the knuckles when LCA's are extended

instead we choose to grind the OEM knuckle to accept this simplified design

63mm stacked length uncompressed and 25mm length compressed

Some people with older cars actually get less noise from the drivetrain because they didn't realize just how bad the original bushings had become despite solid mounts naturally transmitting more noise than rubber

starting with the easy part

Fits Nuke Performance Full Flow AN Hose Ends

Delrin front sway bar bushings for S13 OEM or aftermarket solid front 25mm diameter swaybars