Shrink chuck 3° SK 40 - 06 - 160

Shrink chuck 3° SK 40 - 06 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For mounting straight-shank tools and inclined flat according to DIN 1835 form E (Whistle Notch)

Wherever reduced interference contours are required

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

For mounting screw-in cutters with thread

JIS B 6339 and DIN 2080

102 x 40 x 21

Improves chip evacuation and decreases the risk for chip jamming

set and data button

(without toolholders and inserts)

minimum and diviation