azdome obd hardwire kit mini usb 3

azdome obd hardwire kit mini usb 3Handy AZDome OBD power supply to permanently power your AZDome dashcam. This Plug&Play OBD power supply simply plugs into the car's OBD connector. It provides your AZDome dashcam with power and will also automatically switch in and out of parking mode. The OBD power supply has a low voltage cut off system, which cuts off the power when the battery voltage drops below 11. 8V.

This DDPai Z50 2CH 4K Wifi GPS dashcam is equipped with Wifi and can therefore be used with the DDPai app

The ADAS system on this DDPai Mini 5 is a built-in ‘Advanced Driver Assistant System’

which means approximately 40 hours of recording

As it is placed at an angle on the windscreen behind the interior mirror

The DDPai Mola N3 Pro is equipped with a super capacitor battery

Because this JYX04 power supply is connected to two different power points (one constant and one switched)

Note: Parking mode works only in combination with the optional DDPai 3-wire or OBD Continuous power supply (see accessories) to power the dashcam when the ignition is switched off

1080p 120/60/30/25/24fps

bringing the total length to 9 meters

This GPS holder is already supplied as standard with the Viofo A119 V3 and is intended as an additional set to enable use of the dashcam in multiple vehicles

*The ADAS system works better in some locations than others depending on the type of (highway) road

The ADAS system on this LUKAS H393 is a built-in ‘Advanced Driver Assistant System’